|
|
| 1. PROFILE VACUUM CALIBRATING TABLE |
| 1 unit |
Single Manifold Flat Die 215 mm |
| 1 unit |
Single Manifold Flat Die 380 mm |
|
| 1 unit |
Single Manifold Flat Die 215 mm |
|
|
|
|
|
|
|
|
2. Embossing
|
| 1 unit |
Embossing Unit Type CPF 630 |
| 1 unit |
Embossing Roll with impression according to specification |
| 2 units |
Water Temperature Cooling units |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
3. Calibration
|
|
| 1 unit |
Calibration Table Type TCPF 5 |
| 3 units |
Calibration Tanks |
| 1 set |
Calibration system for profile D5 |
| 1 set |
Calibration system for profile stater strip |
|
2 sets |
Calibration system for profile undersill trim |
| 1 set |
Calibration system for outside corner post |
| 1 set |
Calibration system for inside corner post |
| 1 set |
Calibration system for profile J-Channel |
| 1 set |
Calibration system for profile H |
|
4. Downstream Equipment
|
|
| 1 unit |
Wheel Puller TPF 300 for siding profiles
8 rolls on 4 shafts mo´veable |
| 1 unit |
Ink Jet Printer |
| 1 unit |
Punching unit for sidings
at inlet of wheel puller |
| 1 unit |
Splitter to seperate twin extruded profiles |
| 1 unit |
Press 18T Type CO 202
basic version for cutting sidings |
| 1 unit |
Cut Off Die
for siding D5 (with notches) for Press 18T |
| 1 unit |
Cut Off Die
for siding profiles outside corner post |
| 5 sets |
Cut Off Dies
for siding accessory profiles |
| 1 unit |
Tilting Table
for recepetion of siding profiles 6 m |
|
|
|
|
;)
